• センサ、タッチセンサの日本語ページ
  • sensor,touch sensor English site

Precautions During Use

Inclination sensor Precautions During Use

Go back to the list of "all products"

About the installation method

Mount the tilt sensor so that the "detection axis" and "tilt direction" are the same.
Otherwise, correct output voltage characteristics will not be obtained. Install the sensors securely so that they do not move.

About the installation direction

Mount the tilt sensor so that the "name plate" is on the top side.
The correct output voltage characteristics cannot be obtained when the "name plate" is attached to the ground side.

About shock resistance

Do not apply strong impacts to the inclination sensors. Otherwise, correct output voltage characteristics will not be obtained.

About acceleration and impact

Note that inclination sensors cannot differentiate inclination levels from acceleration or impacts. Therefore, the output voltage will vary if acceleration or impacts are applied even at a constant inclination angle.

About the operating environment

Avoid using or storing the sensors in locations subject to direct sunlight, with sudden temperature change, or where water, oil, chemicals, dust, or corrosive gases may contact the sensors. Note also that the sensors lifespan and performance are greatly affected by condensation and frost.

 

 

  • Back
Go to page top