Model MGM-3*4013-PC High-sensitivity Multi-type Magnetic Guide Sensor
Application
- Automatic guided vehicles guidance
Features
- High-sensitivity magnetic sensor that detects the magnetism at three points.
- Perfect as a guide sensor for automatic guided vehicles (AGV). The sensitivity can be lowered to adapt to the usage environment.
- Open drain output to output directly to digital circuits.
- PCB not enclosed in a case to increase the mounting possibilities.
International Standards
- Our products do not have overseas safety regulations such as CE mark, UL standard, EN standard etc.
- Products is compliant to the RoHS directive.
* Please consult about "change of specification" and "request of specification" of the product.
Rating/Performance
Rating / Performance
| Model | MGM-3N4013-PC | MGM-3S4013-PC |
|---|---|---|
| Detection Surface | Front side detection | |
| Detection Sensitivity | 400 μT ± 100 μT (With a magnet tape of 30×30×t1.5mm) | |
| Power Supply Voltage | 12 V to 24 V DC (Operating voltage range: 10 V to 30 V DC) | |
| Current Consumption | 50 mA DC or less | |
| Output | Pch MOSFET Open drain 30V DC 100mA DC or less | |
| Output Residual Voltage | 1 V DC or less (Load current 100 mA DC) | |
| Operation Status | Normally open (Output ON with magnetic field) | |
| Operation Indicator | Red LED (Lit when On output) | |
|
Number of Detection
Points / Pitch
|
3 point / 24 mm | |
| Response Time | 500 μs or less | |
| Hysteresis | 30 μT or less (With a magnet tape of 30×30×t1.5mm) | |
| Typical Detection Distances |
64 mm (*With MG50-1 series) | |
| Operating Set Distance | 5 to 45 mm (*With MG50-1 series) | |
| Detection Polarity | N-pole | S-pole |
| Temperature Range | -10 to 60 °C (-20 to 70 °C storage temperature range) (Without dew condensation or or icing) | |
| Humidity Range | 90 % RH or less (90 % RH or less storage humidity range)(Without dew condensation) | |
| Vibration Resistance | 10 to 55 Hz, 1.5mm double amplitude in X, Y, and Z directions for 2 hours each (at power off) | |
| Shock Resistance | 500 m/s² (Approx. 50 G) in X, Y, and Z directions 3 times each (at power off) | |
| Connector | Connector: SMR-05V-N (5-pin)(from J.S.T. Mfg. Co., Ltd.) ［Connections］Housing: SMP-05V, Contact: SHF-001T-0.8BS (from J.S.T. Mfg. Co., Ltd.) |
|
*For a detailed specification of the other, please refer to specifications.
Outline Dimensions / Output Circuit
Outline Dimensions
Output Circuit
Precautions During Use
- The detection characteristics will vary if magnetism generating devices, such as inverters or motors, are near the magnetic sensor mounting location. Check the characteristics before using the sensor.
- Use non-magnetic metal for the mounting screw and the casing.
- When using a metal casing, pay attention that the PCB and the parts do not contact.
- Note that the sensor may not operate correctly when the sensitivity is high due to ambient temperature change and magnetic noise.
- See General Precautions During Use for automatic guided vehicles magnetic sensors for other precautions.
